Gear Selector Housing

COMPONENT NOTES AND INFORMATION
1 Shift knob
2 Collar
3 Retaining collar
4 Spring collar
- Removing, refer to Fig. 1, below.
- Installing, refer to Fig. 2, below.
5 Boot
- Pull off from frame
- Connect to shift knob before installing
6 Rubber cover with frame
- Always remove and install together
- After installing, install boot -5-
7 Plastic nut
- Attaches console to gearshift housing -11-
- Remove before removing gear selector mechanism
8 Spacer sleeve
- Installed between console and gearshift housing -11-
9 Gasket
- Between gearshift housing and floor
- Self-adhesive
- Attach to gearshift housing
10 Hex bolt
- For mounting plate to gearshift housing
- Tighten to: 15 Nm (11 ft lbs)
11 Gearshift housing
12 Gasket
- Self-adhesive
- Attach to underside of gearshift housing
13 Gasket Install between selector cables and gearshift housing
14 Center console

PROCEDURES





Fig. 1 Shift lever boot, removing
- Turn boot inside out.
- Pry off spring collar with screwdriver.
- Remove retaining collar.





Fig. 2 Shift lever boot, installing
- Turn boot inside out.
- Insert collar -A- and clamp boot with retaining collar -B-.
Installation position:
Shoulder on retaining collar faces toward spring collar.
- Install shift knob and clip spring collar -C- into shift knob inner groove.
- Install boot over rubber cover to frame.