Gearshift Lever, Repairing

Gearshift lever, repairing






1. Sleeve
Approximately 20 mm from gearshift knob
Holds trim in position

2. Locking washer
3. Spacer
4. Compression spring
5. Shift lever guide
6. Circlip

7. Washer
Cone faces shift lever guide

8. Gearshift lever
9. Cotter pins
10. 25 Nm (18 ft lb)
11. Cover

12. 25 Nm (18 ft lb)
Install after installing heat shield

13. Selector cable at selector bracket
14. Gearshift cable at shift lever
15. Selector bracket
16. Bearing plate
17. 15 Nm (11 ft lb)
18. Pivot stud

19. Cap
Installing, section 34-100

20. Bushing

21. Selector housing
After installation of complete gearshift lever, install selector housing in bearing plate

22. Torsion spring

23. Bushing guide
Rests on bushing

24. Bushing
25. Locking washer

26. Bushing
Fits only in one position