Sunroof Motor - Adjustment Procedure
86VW1Applies To
QUANTUM
1985-1986
Group
60
Subject
Electric Sunroof
Part Identifier
Key Points
Sunroof motor adjustment procedure
A178
Number
86 - 02
March 27, 1986
Note
Refer to Quantum Repair Manual 1982-1985, Group 60, for sunroof repair information.
Use the following procedure when installing sunroof motor:
- apply LOCTITE (R) to all screws
- install all screws but do not tighten
- tighten both screws (1)
- tighten screw (2)
Sunroof motor, adjusting
CAUTION
Do not make adjustment to sunroof motor after tilting sunroof up and then closing.. Adjustment will not be correct.
Note
Before adjusting sunroof motor
- open sunroof to rear
- close sunroof
- disengage sunroof motor from drive gear by moving lever (B) in direction of arrow cast on motor
- insert hand crank into drive pinion (A) and turn to right
- turn drive pinion until tab aligns with hole in cam according to illustration (closed position of sunroof)
- engage sunroof motor to drive gear by moving lever (B) in opposite direction of arrow cast on motor
- recheck alignment
- readjust if necessary