Steering Pad Switch Circuit

AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM (w/ Multi-display without DVD Player): Steering Pad Switch Circuit; 2013 MY Corolla [07/2012 -]
- Steering Pad Switch Circuit

DESCRIPTION

This circuit sends an operation signal from the steering pad switch assembly*1 or steering pad switch LH*2 to the radio and display receiver assembly.

If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly*1 or steering pad switch LH*2.

If there is a short in the circuit, the same condition as when a switch is continuously depressed occurs.

Therefore, the radio and display receiver assembly cannot be operated using the steering pad switch assembly*1 or steering pad switch LH*2, and also the radio and display receiver assembly itself cannot function.

* *1: w/ Steering Pad Switch Assembly

* *2: w/ Steering Pad Switch LH

WIRING DIAGRAM

INSPECTION PROCEDURE

NOTICE:
The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System Service Precautions.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (STEERING PAD SWITCH SIGNAL)

(a) Disconnect the E129 radio and display receiver assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

*1: w/ Steering Pad Switch Assembly

NG -- INSPECT STEERING PAD SWITCH

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Problem Symptoms Table

2. INSPECT STEERING PAD SWITCH

(a) Disconnect the Y1 steering pad switch assembly*1 or steering pad switch LH*2 connector (for Type A).

*1: w/ Steering Pad Switch Assembly

*2: w/ Steering Pad Switch LH

(b) Disconnect the Y1 steering pad switch assembly*1 or steering pad switch LH*2 connector (for Type B).

*1: w/ Steering Pad Switch Assembly

*2: w/ Steering Pad Switch LH

*1: w/ Steering Pad Switch Assembly

Text in Illustration

NG -- REPLACE STEERING PAD SWITCH Removal
OK -- Continue to next step.

3. INSPECT SPIRAL CABLE SUB-ASSEMBLY

(a) Disconnect the Y1 steering pad switch assembly*1 or steering pad switch LH*2 connector.

*1: w/ Steering Pad Switch Assembly

*2: w/ Steering Pad Switch LH

(b) Disconnect the E6 spiral cable sub-assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

(d) After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise. Then while rotating the spiral cable sub-assembly 5 times counterclockwise, measure the resistance as shown in the table below.

Standard Resistance:

NOTICE:
* The spiral cable sub-assembly is an important part of the SRS airbag system. Incorrect removal or installation of the spiral cable sub-assembly may prevent the airbag from deploying. Refer to the pages shown in the brackets.
* As the spiral cable sub-assembly may break, do not rotate the spiral cable sub-assembly more than the specified amount.

HINT
* Removal Removal
* Installation Installation

Text in Illustration

NG -- REPLACE SPIRAL CABLE SUB-ASSEMBLY Removal

OK -- REPAIR OR REPLACE HARNESS OR CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY)