ABS (Antilock Brake System)

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ANTI-LOCK BRAKE SYSTEM: DIAGNOSTIC TROUBLE CODE CHART; 2013 MY Corolla [07/2012 -]

NOTICE:
Turn the ignition switch off before removing parts.

HINT
* If no malfunction is found when inspecting parts, inspect the skid control ECU and ground points for poor contact.
* If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC. For details of each code, refer to the page for the respective DTC Code in the DTC chart.
* When 2 or more DTCs are detected, perform circuit inspection one by one until the problem is identified.
* Inspect the fuses and relays before investigating the trouble areas as shown in the table below.

ABS DTC









*1: Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed:

1. Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.

2. Clear the DTCs.

HINT
In some cases, the Techstream cannot be used when the ABS warning light remains on.

ABS Test Mode DTC