Removal (from 07/2011)
WINDOW / GLASS: QUARTER WINDOW GLASS (for Hatchback): REMOVAL
HINT
* Use the same procedure for both the RH and LH sides.
* The procedure described below is for the LH side.
1. REMOVE DECK BOARD ASSEMBLY Removal (from 07/2011)
2. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)
Removal (from 07/2011)
3. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)
Removal (from 07/2011)
4. REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type)
Removal (from 07/2011)
5. REMOVE FRONT DOOR SCUFF PLATE
HINT
Use the same procedure as for the RH side Removal (from 07/2011).
6. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP
HINT
Use the same procedure as for the RH side Removal (from 07/2011).
7. SEPARATE FRONT SEAT OUTER BELT ASSEMBLY
HINT
Use the same procedure as for the RH side Removal (from 07/2011).
8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY
HINT
Use the same procedure as for the RH side Removal (from 07/2011).
9. REMOVE CENTER PILLAR UPPER GARNISH
HINT
Use the same procedure as for the RH side Removal (from 07/2011).
10. REMOVE NO. 2 ROOM LIGHT ASSEMBLY Removal (from 07/2011)
11. REMOVE JACK HANDLE (for RH Side)
12. REMOVE REAR FLOOR FINISH PLATE Removal (from 07/2011)
13. SEPARATE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY
HINT
Use the same procedure as for the RH side Removal (from 07/2011).
14. REMOVE DECK TRIM SIDE PANEL ASSEMBLY
HINT
Use the same procedure as for the RH side Removal (from 07/2011).
15. REMOVE ROOF SIDE INNER GARNISH
HINT
Use the same procedure as for the RH side Removal (from 07/2011).
16. REMOVE REAR ROOF SIDE RAIL GARNISH
HINT
Use the same procedure as for the RH side Removal (from 07/2011).
17. REMOVE QUARTER WINDOW MOULDING
(a) Using a knife, cut off the quarter window moulding, as shown in the illustration.
Text in Illustration
NOTICE:
Do not damage the vehicle body with the knife.
HINT
Make a partial cut in the quarter window moulding. Then pull and remove it by hand.
18. REMOVE QUARTER WINDOW GLASS
(a) Apply protective tape to the installation area on the quarter window glass on the vehicle body.
Text in Illustration
(b) Place matchmarks on the quarter window glass and vehicle body on the locations indicated in the illustration.
Text in Illustration
HINT
Matchmarks do not need to be placed if the quarter window glass is not going to be reused.
(c) Pass a piano wire between the vehicle body and glass from the interior.
Text in Illustration
(d) Tie both wire ends to wooden blocks or similar objects.
(e) Cut through the adhesive by pulling the piano wire around the quarter window glass.
NOTICE:
When separating the quarter window glass, take care not to damage the paint or the interior and exterior ornaments.
(f) Using suction cups, disengage the 3 clips and remove the quarter window glass.
19. REMOVE QUARTER WINDOW CLIP
(a) Using a scraper, remove the 3 quarter window clips.
NOTICE:
Be sure to replace the quarter window clip with a new one.
20. REMOVE QUARTER WINDOW GLASS SPACER
(a) Using a scraper, remove the 2 quarter window glass spacers.
NOTICE:
Be sure to replace the quarter window glass spacer with a new one.