Installation (from 07/2011)

CLUTCH: CLUTCH PEDAL SWITCH (for Hatchback): INSTALLATION

1. INSTALL NO. 2 CLUTCH START SWITCH ASSEMBLY

(a) Install the No. 2 clutch start switch assembly to the clutch pedal support sub-assembly and temporarily tighten the lock nut.

HINT
Tighten the lock nut to the specified torque when adjusting the clutch pedal.

2. INSTALL CLUTCH START SWITCH ASSEMBLY

(a) Install the clutch start switch assembly to the clutch pedal support sub-assembly with the nut.

Torque : 16 Nm (160 kgf-cm, 12 ft-lbf)

(b) Connect the clutch start switch connector.

(c) With the clutch pedal fully depressed, check that the clearance shown in the illustration is as specified.





Text in Illustration





Standard clearance:

2.1 to 5.1 mm (0.083 to 0.201 in.)

3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag) Installation (from 07/2011)

4. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Installation (from 07/2011)

5. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL Installation (from 07/2011)

6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation (from 07/2011)

7. INSPECT CLUTCH START SYSTEM On-Vehicle Inspection (from 07/2011)