Installation (from 07/2011)

CRUISE CONTROL: CLUTCH SWITCH (for Hatchback): INSTALLATION

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Airbag System (for Hatchback with VSC/Built-in Type Yaw Rate Sensor).

1. INSTALL NO. 2 CLUTCH START SWITCH ASSEMBLY

(a) Fully loosen the lock nut of the No. 2 clutch start switch assembly.

(b) Adjust the No. 2 clutch start switch assembly until the center of the clutch pedal pad is at the standard height Adjustments.

(c) Tighten the lock nut and ensure that the threaded portion is in contact with the cushion.

Torque : 16 Nm (160 kgf-cm, 12 ft-lbf)

(d) Connect the connector.

2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Installation (from 07/2011)

3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag) Installation (from 07/2011)

4. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag) Installation (from 07/2011)

5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation (from 07/2011)

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

7. INSPECT SRS WARNING LIGHT (w/ Knee Airbag)

Airbag System (for Hatchback with VSC/Built-in Type Yaw Rate Sensor)