Installation (from 07/2011)

1NZ-FE ENGINE CONTROL: MASS AIR FLOW METER (for Hatchback): INSTALLATION

1. INSTALL MASS AIR FLOW METER

(a) Install a new O-ring to the mass air flow meter.

NOTICE:
Do not twist the O-ring.

(b) Install the mass air flow meter with the 2 screws.

Torque : 1.0 Nm (10 kgf-cm, 9 in-lbf)

NOTICE:
* If a component has been dropped or subjected to a strong impact, replace it.
* Make sure that the O-ring is not damaged or does not jump out of position during installation.

HINT
Perform "Inspection After Repairs" after replacing the mass air flow meter Programming and Relearning.

(c) Connect the mass air flow meter connector.

(d) Engage the wire harness clamp.