Reassembly (from 07/2011)
DOOR / HATCH: BACK DOOR (for Hatchback): REASSEMBLY
1. APPLY BODY GREASE
2. INSTALL NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE Installation (from 07/2011)
3. INSTALL NO. 6 BACK DOOR NAME PLATE Installation (from 07/2011)
4. INSTALL SYMBOL EMBLEM Installation (from 07/2011)
5. INSTALL PACKAGE TRAY TRIM HANGER
HINT
Use the same procedures for the opposite side.
(a) Install the package tray trim hanger.
6. INSTALL BACK DOOR NO. 2 WIRE
(a) Engage the 4 clamps and connect the connector.
Text in Illustration
(b) Engage the hook and install the wire harness with the bolt.
Torque : 8.4 Nm (85 kgf-cm, 74 in-lbf)
7. INSTALL REAR WINDOW NO. 1 WIRE (w/ Rear Window Defogger)
(a) Engage the hook and install the bolt.
Text in Illustration
Torque : 8.4 Nm (85 kgf-cm, 74 in-lbf)
(b) Engage the clamp and install the wire harness.
8. INSTALL LICENSE PLATE LIGHT ASSEMBLY Installation (from 07/2011)
9. INSTALL BACK DOOR PANEL CUSHION
HINT
Use the same procedures for the opposite side.
(a) Install the new back door panel cushion.
10. INSTALL BACK DOOR PANEL NO. 2 PROTECTOR
(a) Using a piece of cloth or similar material, rub off any double-sided tape remaining on the back door panel.
Text in Illustration
NOTICE:
Installing the back door panel protector with any double-sided tape remaining on the back door panel may cause adhesion failure. Therefore, completely remove the double-sided tape.
(b) Using a non-residue solvent, clean the attachment surface.
(c) Remove the double-sided tape backing of the new back door panel protector.
(d) Install the back door panel protector with 2 clips.
NOTICE:
Thoroughly press the back door panel protector to ensure that it adheres.
11. INSTALL BACK DOOR PANEL NO. 1 PROTECTOR
HINT
Use the same procedures as for the No. 2.
12. INSTALL REAR WASHER NOZZLE (w/ Rear Wiper) Installation (from 07/2011)
13. INSTALL CENTER STOP LIGHT ASSEMBLY Installation (from 07/2011)
14. INSTALL REAR LIGHT COVER
(a) Engage the 6 claws and install the rear lamp cover.
15. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY (w/ Power Door Lock)
16. INSTALL BACK DOOR OUTSIDE HANDLE SUB-ASSEMBLY (w/o Power Door Lock)
(a) Install the back door outside handle.
17. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY (w/ Power Door Lock)
18. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY (w/o Power Door Lock)
19. INSTALL BACK DOOR LOCK CONTROL ASSEMBLY (w/o Power Door Lock)
(a) Install the back door lock control with the 2 nuts.
Torque : 4.9 Nm (50 kgf-cm, 43 in-lbf)
(b) Engage the clamp.
NOTICE:
Make sure to pass the cable behind the wire harness.
20. INSTALL BACK DOOR GARNISH NO. 2 RETAINER (w/ Cover)
(a) Install the back door garnish No. 2 retainer with the 2 nuts.
Torque : 4.9 Nm (50 kgf-cm, 43 in-lbf)
21. INSTALL BACK DOOR LOCK CYLINDER ASSEMBLY (w/ Power Door Lock)
(a) Engage the 2 claws and install the back door lock cylinder.
(b) Install the back door lock cylinder with the 2 nuts.
Torque : 4.9 Nm (50 kgf-cm, 43 in-lbf)
(c) Connect the connector.
22. INSTALL BACK DOOR LOCK CYLINDER ASSEMBLY (w/o Power Door Lock)
(a) Install the back door lock cylinder with the 2 nuts.
Torque : 4.9 Nm (50 kgf-cm, 43 in-lbf)
23. INSTALL BACK DOOR LOCK CONTROL ROD (w/o Power Door Lock)
(a) Install the back door lock control rod.
24. INSTALL DOOR PULL HANDLE
(a) Engage the 4 claws and install the door pull handle.
25. INSTALL BACK DOOR LOCK ASSEMBLY (w/ Power Door Lock) Installation (from 07/2011)
26. INSTALL BACK DOOR LOCK ASSEMBLY (w/o Power Door Lock) Installation (from 07/2011)
27. INSTALL REAR WIPER MOTOR GROMMET (w/ Rear Wiper) Installation (from 07/2011)
28. INSTALL REAR WIPER MOTOR ASSEMBLY (w/ Rear Wiper) Installation (from 07/2011)
29. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY (w/ Rear Wiper) Installation (from 07/2011)
30. INSTALL REAR WIPER ARM HEAD CAP (w/ Rear Wiper) Installation (from 07/2011)
31. INSTALL BACK DOOR TRIM BOARD
(a) Engage the 11 clips and install the back door trim board.
32. INSTALL REAR SPOILER SUB-ASSEMBLY (w/ Rear Spoiler) Installation (from 07/2011)
33. INSTALL REAR SPOILER COVER LH (w/ Rear Spoiler) Installation (from 07/2011)
34. INSTALL REAR SPOILER COVER RH (w/ Rear Spoiler)
HINT
Use the same procedure as for the LH side.