Installation

2GR-FE ENGINE CONTROL: HEATED OXYGEN SENSOR: INSTALLATION

1. INSTALL NO. 2 OXYGEN SENSOR (for Bank 2 Sensor 2)

(a) Using SST, install the No. 2 oxygen sensor to the front exhaust pipe assembly.





Text in Illustration





SST : 09224-00010

without SST - Torque : 44 Nm (449 kgf-cm, 33 ft-lbf)

with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)

NOTICE:
* The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
* The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Service Precautions.
* The "with SST" torque value is effective when SST is parallel to the torque wrench.

2. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation

3. INSTALL OXYGEN SENSOR (for Bank 1 Sensor 2)

(a) Using SST, install the oxygen sensor to the center exhaust pipe assembly.





Text in Illustration





SST : 09224-00010

without SST - Torque : 44 Nm (449 kgf-cm, 33 ft-lbf)

with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)

NOTICE:
* The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
* The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Service Precautions.
* The "with SST" torque value is effective when SST is parallel to the torque wrench.

4. INSTALL NO. 3 FRONT EXHAUST PIPE SUB-ASSEMBLY Installation

5. INSPECT FOR EXHAUST GAS LEAK

6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation

7. INSTALL FRONT DOOR SCUFF PLATE LH Installation

8. INSTALL NO. 1 ENGINE UNDER COVER

9. INSTALL NO. 2 ENGINE UNDER COVER