Removal

DOOR LOCK: REAR DOOR LOCK: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG Disassembly

3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL Disassembly

4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

5. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY Disassembly

6. REMOVE REAR DOOR SERVICE HOLE COVER Disassembly

7. REMOVE REAR DOOR GLASS RUN Disassembly

8. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY Disassembly

9. REMOVE REAR DOOR GLASS SUB-ASSEMBLY Disassembly

10. REMOVE REAR DOOR LOCK ASSEMBLY

(a) Using a T30 "TORX" socket wrench, remove the 3 screws.





(b) Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame.

(c) Remove the door lock wiring harness seal from the rear door lock assembly.





(d) Using a screwdriver, disengage the claw.





HINT
Tape the screwdriver tip before use.

(e) Remove the rear door lock remote control cable assembly from the rear door lock assembly.





(f) Using a screwdriver, disengage the 3 claws.





HINT
Tape the screwdriver tip before use.

(g) Remove the rear door inside locking cable assembly from the rear door lock assembly.