Installation

LIGHTING (EXT): STOP LIGHT SWITCH: INSTALLATION

1. INSTALL STOP LIGHT SWITCH ASSEMBLY

(a) Insert the stop light switch assembly until the threaded sleeve hits the pedal.





NOTICE:
When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

(b) Make a quarter turn clockwise to install the stop light switch assembly.





Torque : 1.5 Nm (15 kgf-cm, 13 in-lbf) or less

NOTICE:
When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

(c) Connect the connector.

(d) Check the protrusion of the plunger.

Protrusion of Plunger





If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary Adjustments.

NOTICE:
Do not depress or support the brake pedal.

2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation