Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: REMOVAL

NOTICE:
While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing the brake system components, do not depress the brake pedal or open/ close the doors while the battery is connected.

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure is for the LH side.
* If the sensor rotor needs to be replaced, replace it together with the front axle hub and bearing assembly.

1. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type) Removal

2. REMOVE REAR DECK FLOOR BOX Removal

3. REMOVE REAR NO. 3 FLOOR BOARD Removal

4. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

5. REMOVE FRONT WHEEL

6. REMOVE FRONT FENDER LINER

(a) Remove the 12 clips, 4 screws, 3 grommets, and front fender liner.

HINT
Use the same procedure for the RH side and LH side.

7. REMOVE FRONT SPEED SENSOR

(a) Remove the 2 clamps and disconnect the front speed sensor connector.

(b) Remove the bolt and No. 2 sensor clamp from the body.

Text in Illustration

(d) Remove the clamp from the shock absorber assembly.

(e) Remove the bolt and front speed sensor.

NOTICE:
* Prevent foreign matter from attaching to the front speed sensor tip.
* Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.