Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: REAR AIRBAG SENSOR: INSTALLATION

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. INSTALL REAR AIRBAG SENSOR

(a) Check that the power switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Insert the pin (stopper) into the body hole to install the rear airbag sensor to the vehicle with the nut.





Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

NOTICE:
* If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
* When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
* Make sure that the pin (stopper) is securely inserted into the body hole.
* Tighten the nut while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.

(d) Connect the connector to the rear airbag sensor.





NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.

(1) Connect the connector as shown in the illustration (when locking, make sure that the outer connector locking sleeve returns to its original position and a click sound can be heard).





Text in Illustration





HINT
When connected, the outer connector locking sleeve will slide. Be sure not to hold the outer connector locking sleeve while connecting, as it may result in an insecure fit.

(e) Check that there is no looseness in the installation parts of the rear airbag sensor.

2. INSTALL NO. 1 HYBRID BATTERY INTAKE DUCT (for RH Side) Installation

3. INSTALL REAR FLOOR BOARD SPACER (for RH Side) Installation

4. INSTALL REAR NO. 1 FLOOR BOARD (for RH Side) Installation

5. INSTALL REAR NO. 2 FLOOR BOARD SUB-ASSEMBLY (for RH Side) Installation

6. INSTALL REAR NO. 1 FLOOR BOARD SUB-ASSEMBLY (for RH Side) Installation

7. INSTALL REAR SIDE SEATBACK ASSEMBLY

for LH Side: Installation

for RH Side: Installation

8. INSTALL REAR DOOR SCUFF PLATE Installation

9. INSTALL REAR SEAT CUSHION ASSEMBLY Installation

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

11. INSTALL REAR NO. 3 FLOOR BOARD Installation

12. INSTALL REAR DECK FLOOR BOX Installation

13. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type) Installation

14. PERFORM DIAGNOSTIC SYSTEM CHECK

(a) Perform a diagnostic system check DTC Check / Clear.

15. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.