Installation

TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RECEIVER: INSTALLATION

1. INSTALL TIRE PRESSURE WARNING RECEIVER

(a) Connect the connector.





(b) Engage the 2 tabs into the holes as shown in the illustration to install the tire pressure warning receiver.

(c) Install the bolt.

Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)

2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH

HINT
* Refer to the procedures from Install Roof Side Inner Garnish Assembly Installation.
* Installation should be performed only for the left side.

3. INSPECT TIRE PRESSURE WARNING SYSTEM

(a) Inspect the tire pressure warning system Test Mode Procedure.