Installation

POWER DISTRIBUTION: MAIN BODY ECU: INSTALLATION

1. INSTALL MAIN BODY ECU

NOTICE:
* Make sure that no foreign objects get on the connecting surfaces.
* Do not touch the ECU connector.

(a) Insert the main body ECU up to the position it contacts the housing sidewall of the guide as shown in the illustration.

Text in Illustration

HINT
Make sure to keep the angle 20° or more as shown in the illustration.

(b) Slide the guide of the main body ECU along the housing sidewall so that it contacts junction block fuses as shown in the illustration.

Text in Illustration

(c) While contacting the main body ECU to side A of the junction block (point of rotation), rotate it downward as shown in the illustration.

Text in Illustration

(d) Press the push area until the claw engages to install the main body ECU.

Text in Illustration

NOTICE:
* Make sure to press only the push area.
* Confirm the engagement of the main body ECU and junction block by listening for the lock sound.
HINT
If a lock sound cannot be heard, visually check the lock part engagement. The engagement can also be confirmed if the main body ECU and junction block are flush.

2. INSTALL DRIVER SIDE JUNCTION BLOCK ASSEMBLY

(a) Engage the claw to install the connector as shown in the illustration.

NOTICE:
Be sure to engage each connector securely.

(b) Engage the claw to lock the connector lock as shown in the illustration.

NOTICE:
Be sure to engage each connector securely.

(d) Engage the 2 clamps to connect the wire harness.

(e) Engage the 6 claws to install the junction block cover.

(f) Install the driver side junction block assembly with the bolt and nut.

Torque : 14 Nm (138 kgf-cm, 10 ft-lbf)

(g) Engage the 2 claws to connect the 2 connectors (5) and (4) as shown in the illustration.

NOTICE:
Be sure to engage each connector securely.

(h) Connect the 3 connectors (3), (2) and (1) as shown in the illustration.

NOTICE:
Be sure to engage each connector securely.

(i) Engage the clamp to connect the wire harness.

3. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

HINT
Refer to the procedure from Install Lower Instrument Panel Sub-assembly Installation.

4. INSTALL UPPER INSTRUMENT PANEL ASSEMBLY

HINT
Refer to the procedure from Install Upper Instrument Panel Assembly Installation.