Installation

2ZR-FXE ENGINE CONTROL: HEATED OXYGEN SENSOR: INSTALLATION

1. INSTALL HEATED OXYGEN SENSOR

(a) Using SST, install the heated oxygen sensor onto the front exhaust pipe.





Text in Illustration





SST : 09224-00010

without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)

with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)

NOTICE:
* This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.81 in.) and SST with a length of 30 mm (1.18 in.) Service Precautions.
* This torque value is effective when SST is parallel to the torque wrench.

(b) Install the wire harness clamp bracket and connect the wire harness clamp.





(c) Pass the sensor connector through the floor panel and install the grommet.





(d) Connect the heated oxygen sensor connector.

2. INSPECT FOR EXHAUST GAS LEAK

3. INSTALL NO. 2 ENGINE UNDER COVER

(a) Install the No. 2 engine under cover with the 4 clips.