Pinout Values and Diagnostic Parameters

TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING SYSTEM: TERMINALS OF ECU

1. CHECK TIRE PRESSURE WARNING ECU

HINT
Inspect the connectors from the back side while the connectors are connected.





(a) Disconnect the R2 tire pressure warning antenna and receiver connector.

(b) Measure the voltage according to the value(s) in the table below.





(c) Connect the R2 tire pressure warning antenna and receiver connector.

(d) Measure the voltage and resistance according to the value(s) in the table below. If the result is not as specified, the ECU may have a malfunction.





(e) Using an oscilloscope, check the waveform 1.





Waveform 1:





HINT
The wavelength becomes shorter as the vehicle speed increases.

(f) Using an oscilloscope, check the waveform 2.





Waveform 2:





HINT
The shape of waves like figure appears approximately 2 times every 3 minutes.