P0A95

HYBRID / BATTERY CONTROL: HYBRID BATTERY SYSTEM: P0A95-123: High Voltage Fuse
P0A95-123 - High Voltage Fuse

DESCRIPTION





WIRING DIAGRAM





INSPECTION PROCEDURE

CAUTION:
- Before inspecting the high-voltage system, take safety precautions to prevent electrical shocks, such as wearing insulated gloves and removing the service plug grip. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high-voltage system.
- After disconnecting the service plug grip, wait for at least 10 minutes before touching any of the high-voltage connectors or terminals.
HINT
At least 10 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.

NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

PROCEDURE

1. CHECK DTC OUTPUT (DTC P0AFC-123 IS OUTPUT) P0A7F

B -- GO TO DTC CHART P0AFC-123
A -- Continue to next step.

2. CHECK SERVICE PLUG GRIP

(a) Turn the power switch off.

(b) Check that the service plug grip is not installed.

NOTICE:
After removing the service plug grip, do not turn the power switch on (READY), unless instructed by the repair manual because this may cause a malfunction.

(c) Measure the resistance according to the value(s) in the table below.





Standard Resistance:





NG -- REPLACE SERVICE PLUG GRIP (HV)

OK -- REPLACE HV BATTERY ASSEMBLY Components

3. REPLACE SERVICE PLUG GRIP (HV)

Components

NEXT -- Continue to next step.

4. RECONFIRM DTC OUTPUT

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

(d) Read output DTCs Hybrid Battery System.

Result:





(e) Disconnect the Techstream from the DLC3.

B -- GO TO DTC CHART Hybrid Control System

A -- RECOVERY TO NORMAL