Reassembly

E351 MANUAL TRANSMISSION / TRANSAXLE: SHIFT AND SELECT LEVER SHAFT: REASSEMBLY

1. INSTALL CONTROL SHAFT COVER OIL SEAL

(a) Using SST and a hammer, install a new control shaft cover oil seal to the control shaft cover.





SST : 09950-60010

09951-00280

SST : 09950-70010

09951-07100

Oil seal installation depth:

28.0 to 29.0 mm (1.10 to 1.14 in.)

2. INSTALL SELECT SPRING NO. 1 SEAT SHAFT SNAP RING

(a) Using a brass bar and a hammer, install the select spring No. 1 seat shaft snap ring.





3. INSTALL NO. 1 SHIFT LEVER INNER

(a) Install the No. 1 shift lever inner to the shift interlock plate.





4. INSTALL SHIFT INTERLOCK PLATE COVER

(a) Install the shift interlock plate cover to the shift interlock plate.





5. INSTALL NO. 1 SELECT SPRING SEAT

(a) Install the No. 1 select spring seat, No. 1 select return compression spring, and shift interlock plate to the shift and select lever shaft.





6. INSTALL NO. 2 SHIFT LEVER INNER

(a) Install the No. 2 shift lever inner, No. 2 select return compression spring and No. 2 select return spring seat to the shift and select lever shaft.





(b) Hold the shift and select lever in a vise using aluminum plates.

(c) Using a brass bar and a hammer, install the select seat snap ring to the shift and select lever shaft.

(d) Using a pin punch (dia 5 mm) and a hammer, install the 2 shift inner lever slotted pins to the shift and select lever shaft.





Clearance A:

0.7 to 1.7 mm (0.0276 to 0.0669 in.)

Clearance B:

-0.4 to 0.5 mm (-0.0157 to 0.0197 in.)

7. INSTALL NO. 2 SELECTING BELLCRANK BUSHING

(a) Coat the 2 No. 2 selecting bellcrank bushings with MP grease and install them to the No. 2 selecting bellcrank.





8. INSTALL NO. 2 SELECTING BELLCRANK DUST COVER

(a) Coat the No. 2 selecting bellcrank dust cover with MP grease and install it to the No. 2 selecting bellcrank.





9. INSTALL SELECTING BELLCRANK SUPPORT SUB-ASSEMBLY

(a) Install the selecting bellcrank support sub-assembly to the No. 2 selecting bellcrank.





(b) Install the No. 2 selecting bellcrank plate washer, wave washer, and nut.





Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

10. INSTALL NO. 1 SELECTING BELLCRANK DUST COVER

(a) Install the No. 1 selecting bellcrank dust cover to the No. 2 selecting bellcrank.





11. INSTALL CONTROL SHIFT LEVER BUSHING

(a) Install the control shift lever bushing to the No. 2 selecting bellcrank.