Installation

U341E AUTOMATIC TRANSMISSION / TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Install the park/neutral position switch assembly to the automatic transaxle.

(b) Temporarily install the 2 bolts.

Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)

(d) Temporarily install the control shaft lever.

(e) Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.

(f) Remove the control shaft lever.

(g) Align the groove with the neutral basic line.

(h) Hold the switch in this position and tighten the 2 bolts.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(i) Using a screwdriver, stake the nut with the lock plate.

(j) Install the control shaft lever with the nut and washer.

Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)

(k) Connect the connector to the park/neutral position switch assembly.

2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Install the transmission control cable assembly to the control shaft lever with the nut.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

(b) Install the transmission control cable assembly to the bracket with a new clip.

3. INSTALL BATTERY CARRIER Installation

4. INSTALL BATTERY Installation

5. INSPECT SHIFT LEVER POSITION Adjustments

6. ADJUST SHIFT LEVER POSITION Adjustments

7. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY Initial Inspection and Diagnostic Overview