Installation

U250E AUTOMATIC TRANSMISSION / TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Install the park/neutral position switch to the manual valve shaft.





(b) Temporarily install the 2 bolts.

(c) Install a new lock plate and tighten the nut.

Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)





(d) Temporarily install the control shaft lever.

(e) Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.





(f) Remove the control shaft lever.

(g) Align the groove with the neutral basic line.





(h) Hold the switch in that position and tighten the 2 bolts.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(i) Using a screwdriver, stake the nut with the lock plate.





(j) Install the control shaft lever with the washer and nut.





Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)

(k) Connect the park/neutral position switch connector.





2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Connect the transmission control cable to the bracket with a new clip.





(b) Connect the transmission control cable assembly to the control shaft lever with the nut.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

3. INSTALL ENGINE UNDER COVER LH

4. INSPECT SHIFT LEVER POSITION Adjustments

5. ADJUST SHIFT LEVER POSITION Adjustments

6. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY Component Tests and General Diagnostics