Air Conditioning System (for Manual Air Conditioning System)

HEATING / AIR CONDITIONING: AIR CONDITIONING SYSTEM (for Manual Air Conditioning System): B1479: Flow Sensor Circuit
B1479 - Flow Sensor Circuit

DESCRIPTION

The A/C flow sensor, which is mounted on the compressor assembly with pulley, is used to detect the amount of refrigerant flow. The A/C flow sensor converts the amount of refrigerant flow that is detected to a voltage value to send it to the A/C amplifier. The voltage value sent from the A/C flow sensor changes depending on the amount of refrigerant flow. As the amount of refrigerant flow becomes larger, the voltage becomes lower. As the amount of refrigerant flow becomes smaller, the voltage becomes higher. The A/C amplifier supplies 5 V to the A/C flow sensor and monitors change in the voltage value sent from the A/C flow sensor. The A/C amplifier then sends a signal to the ECM via CAN communication to allow the ECM to control the engine speed while the air conditioning is on.





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body / Air Conditioner / Data List.

(e) Check the value(s) by referring to the table below.

Air Conditioner





OK:

The display is as specified in the Normal Condition column.

Result:





B -- REPLACE AIR CONDITIONING AMPLIFIER Removal

C -- REPLACE COMPRESSOR ASSEMBLY WITH PULLEY (A/C FLOW SENSOR)
A -- Continue to next step.

2. READ VALUE USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body / Air Conditioner / Data List.

(e) Check the value(s) by referring to the table below.

Air Conditioner





Result:





B -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Air Conditioning System (for Manual Air Conditioning System)
A -- Continue to next step.

3. REPLACE COMPRESSOR ASSEMBLY WITH PULLEY (A/C FLOW SENSOR)

(a) Replace the compressor assembly with pulley (A/C flow sensor) Removal.

HINT
Since the compressor assembly with pulley (A/C flow sensor) cannot be inspected while it is removed from the vehicle, replace the compressor assembly with pulley (A/C flow sensor) with a new or a known good one and check that the condition returns to normal.

(b) Check for the DTC.

Result:





B -- CHECK HARNESS AND CONNECTOR (COMPRESSOR ASSEMBLY WITH PULLEY - A/C AMPLIFIER)

A -- END

4. CHECK HARNESS AND CONNECTOR (COMPRESSOR ASSEMBLY WITH PULLEY - A/C AMPLIFIER)

(a) Disconnect the A/C amplifier connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE AIR CONDITIONING AMPLIFIER Removal