Installation
P314 HYBRID TRANSMISSION / TRANSAXLE: SHIFT LEVER POSITION SENSOR: INSTALLATION
1. INSTALL SHIFT LEVER POSITION SENSOR
(a) Install the shift lever position sensor to the manual valve shaft.
(b) Temporarily install the 2 bolts.
(c) Install a new lock plate and tighten the nut.
Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)
(d) Temporarily install the control shaft lever to the manual valve shaft.
(e) Turn the lever clockwise until it stops, then turn it counterclockwise 2 notches.
(f) Remove the control shaft lever from the manual valve shaft.
(g) Align the protruding part with the neutral basic line.
Text in Illustration
NOTICE:
There is play on the nut stopper side (protruding part). Align the center point of the range of the play with the neutral basic line.
(h) Tighten the 2 bolts in the order shown in the illustration.
Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)
(i) Using a screwdriver, secure the nut with the lock plate.
(j) Install the control shaft lever, washer, and nut to the manual valve shaft.
Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)
(k) Connect the connector to the shift lever position sensor.
2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Move the shift lever to the N position.
(b) Install a new clip to the control bracket.
(c) Install the transmission control cable assembly to the control bracket.
Text in Illustration
NOTICE:
* Make sure that the A claws on the clip are securely fit into the bracket holes.
* Make sure that the cable is securely installed inside the B claws of the clip.
(d) Install the transmission control cable assembly to the control shaft lever with the nut.
Torque : 15 Nm (153 kgf-cm, 11 ft-lbf)
3. INSPECT SHIFT LEVER POSITION SENSOR POSITION Adjustments
4. ADJUST SHIFT LEVER POSITION SENSOR POSITION Adjustments
5. INSPECT SHIFT LEVER POSITION Adjustments
6. ADJUST SHIFT LEVER POSITION Adjustments
7. INSTALL ENGINE UNDER COVER RH
8. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
9. INSTALL ENGINE UNDER COVER LH
10. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH