Removal

LIGHTING (INT): REAR DOOR COURTESY SWITCH: REMOVAL

HINT
* Use the same procedure for the RH and LH sides.
* The procedure described below is for the LH side.

1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing Built-in Type Yaw Rate Sensor.

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Service Precautions.

2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER Removal

3. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. REMOVE REAR SEAT CUSHION ASSEMBLY Removal

5. REMOVE REAR SEAT CUSHION LOCK HOOK Removal

6. REMOVE REAR SIDE SEATBACK ASSEMBLY Removal

7. REMOVE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY

(a) Disconnect the connector.

(b) Using a T30 "TORX" socket wrench, remove the screw and rear door courtesy light switch assembly.