Conditions When Inspection of SRS Parts Is Necessary

Repairs and Inspections Required After a Collision

CONDITIONS WHEN INSPECTION OF SRS PARTS IS NECESSARY

(a) When the vehicle is damaged in a collision even when the SRS parts are not deployed.

(b) When an SRS system DTC is output.


PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following system(s) after the cable is reconnected:





Perform zero point calibration and sensitivity check if any of the following conditions occur:

* The occupant detection ECU is replaced.

* Accessories (seatback tray and seat cover, etc.) are installed.

* The front passenger seat is removed from the vehicle.

* One of the bolts that is used to install the front passenger seat is removed and reinstalled.

* The passenger airbag ON/OFF indicator ("OFF") comes on when the front passenger seat is not occupied.

* The vehicle is brought to the workshop for repair due to an accident or a collision.

(a) Perform a diagnostic system check.

(b) When the SRS parts are deployed (including when only an airbag or pretensioner is deployed) due to a collision, be sure to replace all sensors in the damaged areas (anywhere in need of repair) and airbag sensor assembly (center airbag sensor).

(c) Visually check the airbag sensors in undamaged areas for defects.

(1) The defects are as follows:

* Cracks on the sensor housing

* Dents on the sensor housing

* Chips on the sensor housing

* Cracks or other damage to the connector

* Damage to the serial number

OK:

No defects are found.

If any of the defects is found, or an airbag sensor has detected a major collision, replace the airbag sensor with a new one.