Installation

TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RECEIVER: INSTALLATION

1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

(a) Connect the connector to the tire pressure warning ECU and receiver.

(b) Engage the 2 tabs into the holes to temporarily install the tire pressure warning ECU and receiver.

(c) Install the bolt to install the tire pressure warning ECU and receiver.

Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)

2. INSTALL ROOF SIDE INNER GARNISH RH

HINT
Use the same procedure as for the LH side Installation.

3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH Installation

4. INSTALL REAR SIDE SEATBACK ASSEMBLY RH Installation

5. INSTALL REAR SEAT CUSHION LOCK HOOK Installation

6. INSTALL REAR SEAT CUSHION ASSEMBLY Installation

7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. INSTALL LUGGAGE TRIM SERVICE HOLE COVER Installation

9. REGISTER TRANSMITTER ID

Registration

10. INSPECT TIRE PRESSURE WARNING SYSTEM

Test Mode Procedure

11. PERFORM INITIALIZATION

Initialization

12. INSPECT SRS WARNING LIGHT

for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor

for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor