Transmission Control Systems: Testing and Inspection

P314 HYBRID TRANSMISSION / TRANSAXLE: HYBRID TRANSAXLE SYSTEM: ON-VEHICLE INSPECTION

1. INSPECT FLUID PRESSURE OF OIL PUMP

NOTICE:
Do the test at normal operating fluid temperature 50 to 80°C (122 to 176°F).

(a) Remove the front fender apron seal LH.

(b) Remove the fluid pump cover plug and O-ring from the hybrid vehicle transaxle assembly.





(c) Install the SST to the hybrid vehicle transaxle assembly.





SST : 09992-00095

09992-00112

09992-00271

(d) Put the engine in inspection mode Component Tests and General Diagnostics.

(e) Measure the fluid pressure.

Standard:





NOTICE:
Be sure to cancel the inspection mode immediately after the transaxle fluid pressure check is completed.

(f) Remove the SST from the hybrid vehicle transaxle assembly.

(g) Install a new O-ring and fluid pump cover plug to the hybrid vehicle transaxle assembly.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(h) Install the front fender apron seal LH.