Installation

2AR-FXE EMISSION CONTROL: EGR COOLER: INSTALLATION

1. INSTALL EGR COOLER ASSEMBLY

(a) Temporarily install 2 new gaskets and the EGR cooler assembly with the bolt (A) and nut (A).





(b) Using an E8 "TORX" socket wrench, install the stud bolt.

Torque : 7.0 Nm (71 kgf-cm, 62 in-lbf)

(c) Temporarily install the bolt (B) and nut (B).

(d) Temporarily install the 2 bolts (C).

(e) Tighten the 4 bolts and 2 nuts.

Bolt (A) and Nut (A) - Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)

Bolt (B) and Nut (B) - Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)

Bolt (C) - Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

NOTICE:
Make sure that all installation surfaces of the EGR cooler assembly are in even contact when tightening the bolts and nuts.

(f) Connect the water by-pass hose.

2. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

Installation