Installation

2AR-FXE ENGINE CONTROL: KNOCK SENSOR: INSTALLATION

1. INSTALL KNOCK CONTROL SENSOR

(a) Install the sensor with the bolt so that the sensor is angled as shown in the illustration.





Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

Text in Illustration





NOTICE:
The acceptable installation angle of the sensor is between 7° upward and 10° downward from the horizontal position.

HINT
Perform "Inspection After Repair" after replacing the knock control sensor Programming and Relearning

(b) Connect the sensor connector.

2. INSTALL INTAKE MANIFOLD

Installation