Removal

2AR-FXE ENGINE CONTROL: ECM: REMOVAL

1. REMOVE LUGGAGE TRIM SERVICE HOLE COVER Removal

2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE ECM

(a) Disconnect the 2 ECM connectors.





(1) Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.

NOTICE:
After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the connectors.

(b) Remove the nut.





(c) Remove the screw (A).

(d) Loosen the screw (B) and remove the ECM.

(e) Remove the screw (B).

(f) Remove the 2 screws and No. 2 ECM bracket.





4. REMOVE NO. 1 RELAY BLOCK COVER

5. REMOVE NO. 1 ECM BRACKET

(a) Remove the nut.





(b) Release the 2 clamps and disconnect the wire harness.

(c) Disconnect the wire harness clamp.





(d) Remove the nut and No. 1 ECM bracket.