Installation

2AR-FXE ENGINE CONTROL: ECM: INSTALLATION

1. INSTALL NO. 1 ECM BRACKET

(a) Install the No.1 ECM bracket with the nut.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

(b) Connect the wire harness clamp.

(c) Install the wire harness and 2 clamps.

(d) Install the nut.

2. INSTALL NO. 1 RELAY BLOCK COVER

3. INSTALL ECM

(a) Install the No.2 ECM brackets to the ECM with the 2 screws.





Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

(b) Temporarily install the screw (B).

(c) Install the ECM with the nut.





Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

(d) Install the screw (A).

Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

(e) Tighten the screw (B).

Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

(f) Connect the 2 ECM connectors and lower the 2 levers.





NOTICE:
* When connecting the connectors, make sure that dirt, water or other foreign matter does not become stuck between the connectors and other part.
* Make sure that the 2 levers are securely locked.

(g) Connect the 2 wire harness clamps.

4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. INSTALL LUGGAGE TRIM SERVICE HOLE COVER Installation

6. PERFORM INITIALIZATION

Service Precautions