Installation

LIGHTING (EXT): REAR COMBINATION LIGHT ASSEMBLY: INSTALLATION

HINT
* Use the same procedure for the RH and LH sides.
* The procedure described below is for the LH side.

1. INSTALL REAR COMBINATION LIGHT ASSEMBLY

(a) Install the rear combination light assembly with the 4 nuts.

Torque : 4.1 Nm (42 kgf-cm, 36 in-lbf)

(b) Engage the clamp.

(c) Connect each connector.

2. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER Installation

3. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK Installation

4. INSTALL LUGGAGE COMPARTMENT FRONT TRIM COVER Installation

5. INSTALL REAR FLOOR FINISH PLATE Installation

6. INSTALL BAGGAGE HOLDER NET (w/ Partition Net) Installation

7. INSTALL SPARE WHEEL COVER ASSEMBLY Installation

8. INSTALL LUGGAGE COMPARTMENT FLOOR MAT Installation

9. INSTALL REAR BUMPER ASSEMBLY

Installation