Removal

SEAT: REAR SEAT RECLINING CONTROL CABLE: REMOVAL

1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing.

for Separate Type Yaw Rate Sensor: Separate Type Yaw Rate Sensor

for Built-in Type Yaw Rate Sensor: Built-in Type Yaw Rate Sensor

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Service Precautions.

2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER Removal

3. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. REMOVE REAR SEAT CUSHION ASSEMBLY Removal

5. REMOVE REAR SEAT CUSHION LOCK HOOK Removal

6. REMOVE REAR SEATBACK ASSEMBLY RH Removal

7. REMOVE NO. 2 ROOM PARTITION COVER Removal

8. REMOVE REAR SEATBACK ASSEMBLY LH Removal

9. REMOVE REAR SIDE SEATBACK ASSEMBLY LH Removal

10. REMOVE REAR SIDE SEATBACK ASSEMBLY RH Removal

11. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH Removal

12. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH Removal

13. REMOVE ROOF SIDE INNER GARNISH LH Removal

14. REMOVE ROOF SIDE INNER GARNISH RH

HINT
Use the same procedure as for the LH side Removal.

15. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY (for LH Side) Removal

16. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY (for RH Side) Removal

17. REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH Removal

18. DISCONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH Removal

19. REMOVE CENTER STOP LIGHT SET Removal

20. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER Removal

21. REMOVE REAR SEAT SHOULDER BELT COVER Removal

22. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY Removal

23. REMOVE NO. 1 ROOM PARTITION BOARD

(a) Using a clip remover, remove the 4 clips.





(b) Disengage the 5 clips and remove the No. 1 room partition board.

24. REMOVE REAR SEATBACK LOCK SUB-ASSEMBLY LH

(a) Remove the 2 nuts and rear seatback lock sub-assembly LH.





25. REMOVE REAR SEATBACK LOCK SUB-ASSEMBLY RH

(a) Disengage the hook as shown in the illustration.





(b) Remove the 2 nuts and rear seatback lock sub-assembly RH.