Removal

THEFT DETERRENT / KEYLESS ENTRY: GLASS BREAKAGE SENSOR ECU: REMOVAL

1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Service Precautions.

2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER Removal

3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. REMOVE FRONT PANEL GARNISH RH Removal

5. REMOVE FRONT DOOR SCUFF PLATE RH

HINT
Use the same procedure for the RH side and LH side Removal.

6. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT
Use the same procedure for the RH side and LH side Removal.

7. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH Removal

8. REMOVE INSTRUMENT SIDE PANEL RH Removal

9. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

10. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY Removal

11. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY Removal

12. REMOVE GLASS BREAKAGE SENSOR ECU

(a) Disconnect the connector.

(b) Remove the nut and glass breakage sensor ECU.