Diagnosis System

DOOR LOCK: WIRELESS DOOR LOCK CONTROL SYSTEM: DIAGNOSIS SYSTEM

1. DESCRIPTION

The ECU stores trouble codes when malfunctions occur.

The diagnostic system allows for reading of the trouble codes from the DLC3.

Use the Techstream to help diagnose and repair the problem.

2. CHECK DLC3

(a) Check the DLC3 General Information.

3. INSPECT AUXILIARY BATTERY VOLTAGE

(a) Measure the auxiliary battery voltage with the power switch off.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the auxiliary battery.

4. SELF-DIAGNOSTIC MODE (USING TECHSTREAM)

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Smart Key / Utility / Wireless Door Lock Diagnosis Mode.

(e) Proceed to the next step in accordance with the prompts on the Techstream screen.

HINT
The electrical key transmitter uses 2 different frequencies alternately for communication. When in self diagnostic mode, one of the channels can be selected or the channels can be automatically switched.

(f) Check that the system has switched to self-diagnostic mode by checking the wireless door lock buzzer output pattern.





(g) Check the diagnostic outputs when the electrical key transmitter sub-assembly switch is held down. The diagnostic outputs can be checked by the interior light and wireless door lock buzzer patterns.





Result