C1ABB

PARK ASSIST / MONITORING: BLIND SPOT MONITOR SYSTEM: C1ABB: Blind Spot Monitor Master Module Beam Axis Inspection Incomplete
C1ABB - Blind Spot Monitor Master Module Beam Axis Inspection Incomplete

DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH.

HINT
This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.





INSPECTION PROCEDURE

PROCEDURE

1. PERFORM BEAM AXIS INSPECTION

(a) Perform beam axis inspection using the Techstream Operation Check.

NEXT -- END