B2286

THEFT DETERRENT / KEYLESS ENTRY: SMART KEY SYSTEM (for Start Function): B2286: Runnable Signal Malfunction
B2286 - Runnable Signal Malfunction

DESCRIPTION

This DTC is stored when a malfunction is detected in the READY signal circuit inside the power management control ECU.

HINT
When the cable is disconnected and reconnected to the negative (-) auxiliary battery terminal, the power source mode returns to the state it was in before the cable was disconnected.





* *: Only detected while a malfunction is present and the power switch is on (IG)

Vehicle Condition and Fail-safe Function when Malfunction Detected





WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
* When using the Techstream with the power switch off, perform either of the following: 1) Turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and vehicle begins, or 2) connect the Techstream to the vehicle, select the vehicle type under manual mode, and then enter the following menus:
for Power Source Control: Body Electrical / Power Source Control / DTC.
for Smart Key: Body Electrical / Smart Key / DTC.
* The smart key system (for Start Function) uses a multiplex communication system (LIN communication system) and the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting How To Proceed With Troubleshooting. Troubleshoot the smart key system (for Start Function) after confirming that the communication systems are functioning properly.
* Inspect the fuses of circuits related to this system before performing the following inspection procedure.
* After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.

HINT

Related Data List and Active Test Items








PROCEDURE

1. CHECK HARNESS AND CONNECTOR (POWER SOURCE) B2271

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR IN CIRCUIT CONNECTED TO POWER SOURCE
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (GROUND) B2271

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

3. CHECK FOR DTC

(a) Clear the DTCs Smart Key System (for Start Function).

(b) Turn the power switch on (IG).

(c) After 25 seconds have elapsed, check if the DTC has been output again.

OK:

DTC B2286 is not output

NG -- REPLACE POWER MANAGEMENT CONTROL ECU Removal

OK -- END (USE SIMULATION METHOD TO CHECK) How To Proceed With Troubleshooting