Cylinder Head Assembly: Specifications
CYLINDER HEAD SUB-ASSEMBLY RHThe cylinder head bolts are tightened in 3 progressive steps.
Step 1
Using a 10 mm bi-hexagon wrench, install and uniformly tighten the 8 cylinder head bolts with the plate washers in several steps and in the sequence shown in the illustration.
Torque 36 Nm (367 kgf-cm, 27 ft-lbf)
Step 2
Mark the cylinder head bolt head with paint as shown in the illustration.
Tighten the cylinder head bolts another 90°.
Step 3
Tighten the cylinder head bolts an additional 90°.
Check that the painted mark is now facing rearward.
CYLINDER HEAD SUB-ASSEMBLY LH
The cylinder head bolts are tightened in 3 progressive steps.
Step 1
Using a 10 mm bi-hexagon wrench, install and uniformly tighten the 8 cylinder head bolts with the plate washers in several steps in the sequence shown in the illustration.
Torque 36 Nm (367 kgf-cm, 27 ft-lbf)
Step 2
Mark the cylinder head bolt head with paint as shown in the illustration.
Tighten the cylinder head bolts another 90°.
Step 3
Tighten the cylinder head bolts an additional 90°.
Check that the painted mark is now facing rearward.
Tighten the 2 bolts in the order shown in the illustration.
Torque 30 Nm (306 kgf-cm, 22 ft-lbf)
SURFACE VARIATION AND CYLINDER HEAD SET BOLT
CAMSHAFT BEARING CAP (for Bank 1)
Make sure of the marks and numbers on the camshaft bearing caps and place them in each proper position and direction.
Temporarily tighten the 8 bearing cap bolts in the order shown in the illustration.
Torque 10 Nm (102 kgf-cm, 7 ft-lbf)
CAMSHAFT BEARING CAP (for Bank 2)
Make sure of the marks and numbers on the camshaft bearing caps and place them in each proper position and direction.
Temporarily tighten the 8 bolts in the order shown in the illustration.
Torque 10 Nm (102 kgf-cm, 7 ft-lbf)
CAMSHAFT HOUSING SUB-ASSEMBLY LH
Install the camshaft housing sub-assembly LH and tighten the 13 bolts in the order shown in the illustration.
Torque 28 Nm (286 kgf-cm, 21 ft-lbf)
Tighten the 8 bolts in the order shown in the illustration.
Torque 16 Nm (163 kgf-cm, 12 ft-lbf)
CAMSHAFT HOUSING SUB-ASSEMBLY RH
Install the camshaft housing sub-assembly RH and tighten the 12 bolts in the order shown in the illustration.
Torque 28 Nm (286 kgf-cm, 21 ft-lbf)
Tighten the 8 bolts in the order shown in the illustration.
Torque 16 Nm (163 kgf-cm, 12 ft-lbf)
INTAKE MANIFOLD TORQUE & SEQUENCE Specifications
EXHAUST MANIFOLD TORQUE & SEQUENCE Specifications
CAMSHAFT GEAR/SPROCKET TORQUE Specifications