Installation

TIRE AND WHEEL: TIRE PRESSURE WARNING RECEIVER (w/ Antenna): INSTALLATION

1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY

(a) Connect the connector to the tire pressure warning receiver assembly.





(b) Install the tire pressure warning receiver assembly with the bolt.

Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)

2. INSTALL INNER ROOF SIDE GARNISH LH Installation

3. INSTALL REAR SIDE SEAT BACK ASSEMBLY LH Installation

4. INSTALL REAR SEAT CUSHION ASSEMBLY Installation

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

6. INSPECT TIRE PRESSURE WARNING SYSTEM

HINT
Test Mode Procedure