Installation

1AR-FE ENGINE CONTROL: AIR FUEL RATIO SENSOR: INSTALLATION

1. INSTALL AIR FUEL RATIO SENSOR

(a) Using SST, install the air fuel ratio sensor to the exhaust manifold.





SST : 09224-00010

without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)

with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)

NOTICE:
* The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
* The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Service Precautions.
* This torque value is effective when SST is parallel to the torque wrench.

Text in Illustration:

(b) Connect the air fuel ratio sensor connector.





(c) Install the wire harness clamp.

2. INSPECT FOR EXHAUST GAS LEAK

3. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR Installation

4. INSTALL INLET AIR CLEANER ASSEMBLY Installation

5. INSTALL COOL AIR INTAKE DUCT SEAL Installation

6. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY Installation