ABS (Antilock Brake System)
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ANTI-LOCK BRAKE SYSTEM: DIAGNOSTIC TROUBLE CODE CHART
NOTICE:
Turn the ignition switch off before removing parts.
HINT
* If no malfunction is found when inspecting parts, inspect the skid control ECU and ground points for poor contact.
* If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC. For details of each code, refer to the respective DTC Code in the DTC chart.
* When 2 or more DTCs are detected, perform circuit inspection one by one until the problem is identified.
* Inspect the fuses and relays before investigating the trouble areas as shown in the table below.
ABS DTC
C0200/31-C0246/23:
C0256/24-C1238/38:
C1239/39-C1251/51 / U0073/94:
*1: Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed:
* Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.
* Clear the DTCs.
HINT
In some cases, the Techstream cannot be used when the ABS warning light remains on.
ABS test mode DTC
