Removal

SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY (for TMC Made): REMOVAL

1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal

4. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal

5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

6. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY Removal

7. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY Removal

8. REMOVE FRONT DOOR SCUFF PLATE LH Removal

9. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH Removal

10. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH Removal

11. REMOVE FRONT DOOR SCUFF PLATE RH Removal

12. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH Removal

13. REMOVE INSTRUMENT PANEL NO. 2 UNDER COVER SUB-ASSEMBLY Removal

14. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY Removal

15. REMOVE CONSOLE BOX POCKET Removal

16. REMOVE CONSOLE BOX CARPET Removal

17. REMOVE CONSOLE BOX ASSEMBLY Removal

18. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

19. REMOVE NO. 1 CONSOLE BOX INSERT FRONT Removal

20. REMOVE NO. 2 CONSOLE BOX INSERT FRONT Removal

21. REMOVE NO. 1 CONSOLE BOX DUCT Removal

22. REMOVE CENTER AIRBAG SENSOR ASSEMBLY

(a) Turn back the carpet.

(b) Disconnect the holder (with connectors).





NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(c) Remove the 3 bolts and center airbag sensor assembly.