Installation

SUPPLEMENTAL RESTRAINT SYSTEM: DRIVER SIDE KNEE AIRBAG ASSEMBLY (for TMMK Made): INSTALLATION

1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

(a) Check that the power switch is turned off.

(b) Check that the battery negative (-) cable is disconnected.

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

(c) Temporarily install the driver side knee airbag assembly with the 2 hooks.





(d) Engage the 2 claws and install the DLC3.

(e) Install the driver side knee airbag assembly with the 4 bolts.





Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(f) Connect the driver side knee airbag connector.

NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH Installation

3. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation

4. INSTALL FRONT DOOR SCUFF PLATE LH Installation

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

NOTICE:
Some systems need initialization after reconnecting the cable to the negative battery terminal.

7. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.