Component Tests and General Diagnostics

TIRE AND WHEEL: TIRE AND WHEEL SYSTEM: INSPECTION

1. INSPECT TIRE

(a) Check the tires for wear and proper inflation pressure.

Cold Tire Inflation Pressure:





(b) Using a dial indicator, check the runout of the tires.





Maximum tire runout:

1.4 mm (0.055 in.)

2. ROTATE TIRES

(a) Rotate the tires as shown in illustration.





3. INSPECT WHEEL BALANCE

(a) Check and adjust the off-the-car balance.

(1) Steel wheel





Maximum imbalance after adjustment:

8.0 g (0.018 lb)

(2) Others (Non-steel wheel)





Maximum imbalance after adjustment:

8.0 g (0.018 lb)

NOTICE:
* Remove dirt, oil, and water from the surface where the balance weight is to be adhered with a cleaning detergent.
* Do not touch the sticking surface of the tape.
* Adhere the sticking type balance weight to the flat position shown in the illustration.
* Push the balance weight securely with a finger to adhere it to the indicated position.
* Do not reuse balance weights.

HINT
The inner side balance weight should be installed by clipping it to the rim.

4. INSPECT FRONT AXLE HUB BEARING LOOSENESS

(a) Inspect the front axle hub bearing looseness Front Axle Hub.

5. INSPECT REAR AXLE HUB BEARING LOOSENESS

(a) Inspect the rear axle hub bearing looseness Rear Axle Hub and Bearing.

6. INSPECT FRONT AXLE HUB RUNOUT

(a) Inspect the front axle hub runout Front Axle Hub.

7. INSPECT REAR AXLE HUB RUNOUT

(a) Inspect the rear axle hub runout Rear Axle Hub and Bearing.