P0A10-263

P311 HYBRID VEHICLE CONTROL: HYBRID CONTROL SYSTEM: P0A10-263: DC / DC Converter Status Circuit High Input
P0A10-263 - DC / DC Converter Status Circuit High Input

DESCRIPTION

Refer to the circuit description for DTC P0A08-264 P0A09.

WIRING DIAGRAM

Refer to the wiring diagram for P0A08-264 P0A08.

INSPECTION PROCEDURE

CAUTION:
- Before inspecting the high-voltage system or disconnecting the low voltage connector of the inverter with converter assembly, take safety precautions such as wearing insulated gloves and removing the service plug grip to prevent electrical shocks. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high-voltage system.
- After disconnecting the service plug grip, wait for at least 10 minutes before touching any of the high-voltage connectors or terminals. After waiting for 10 minutes, check the voltage at the terminals in the inspection point in the inverter with converter assembly. The voltage should be 0 V before beginning work.
HINT
Waiting for at least 10 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.

PROCEDURE

1. CHECK DTC OUTPUT (HV)

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

(d) Check if DTCs are output.

Result:

DTC P0A10-263 and other DTCs are output.

YES -- GO TO DTC CHART
NO -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR

(a) Disconnect the On1 battery pack wire connector Components.

(b) Turn the power switch on (IG).

(c) Measure the voltage according to the value(s) in the table below.

Standard voltage:

NOTICE:
Turning the power switch on (IG) with the battery pack wire connector disconnected causes other DTCs to be stored. Clear the DTCs after performing this inspection.

NG -- CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - BATTERY PACK WIRE)
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (BATTERY PACK WIRE CONNECTOR - HYBRID VEHICLE CONVERTER)

CAUTION:
Be sure to wear insulated gloves.

(a) Check that the service plug grip is not installed.

(b) Disconnect the n4 hybrid vehicle converter (DC/DC converter) connector Components.

(c) Turn the power switch on (IG).

(d) Measure the voltage according to the value(s) in the table below.

Standard voltage:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE HYBRID VEHICLE CONVERTER Components

4. CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - BATTERY PACK WIRE)

(a) Disconnect the A61 hybrid vehicle control ECU connector.

(b) Turn the power switch on (IG).

(c) Measure the voltage according to the value(s) in the table below.

Standard voltage: