Canada - Body - Power Window Initialization Procedure

Bulletin
3228

Issue Date
August 11, 2009

Market
Canada

Title:
INITIALIZATION OF POWER WINDOW DURING PDS

Component
GENERAL INFORMATION

Models
'10 Avalon


INTRODUCTION:
As a result of the removal of the Short Pin, the "one-touch open and close" and "jam protection" functions of the driver's door power window and front passenger door power window, will be inoperative. This is due to a loss of power to the respective door window position memory stored in the microcomputers for each door power window switch.

Initialize the driver's door power window and the front passenger's door power window after installing the Short Pin in its original location during Pre-Delivery Service (PDS).

NOTE
Anytime the battery terminal has been disconnected, the driver's door power window and front passenger's door power window MUST be re-initialized after reconnecting the battery terminal.







APPLICABILITY:







WARRANTY INFORMATION:

INITIALIZATION PROCEDURE:

Driver and Passenger Door Power Window Switch







1. Turn the ignition switch to the "IG-ON" position.

NOTE
When not initialized, the power window switch will blink.

2. Push down and hold the driver's door power window switch to completely open the window.







3. Pull and hold up the door power window switch until the window closes. Continue holding the switch until the switch stops blinking and remains illuminated.
4. Check for proper operation of the "one-touch open and close" function by fully pushing the switch briefly to the "DOWN" and "UP" positions.

NOTE:
Jam protection function is enabled through the above initialization procedure.