Body - Power Window Initialization Procedure
T-SB-0230-09July 27, 2009
Initialization of Power Window During PDS
Service Category
General
Section
Pre-Delivery Service
Market
USA
Applicability
Introduction
As a result of the removal of the Short Pin, the "one-touch open and close" and "jam protection" functions of the driver's and front passenger's door power window will be inoperative. This is due to a loss of power to the window position memory stored in the microcomputers for each door's power window switch.
Initialize the driver's door and front passenger's door power window after installing the Short Pin in its original location during Pre-Delivery Service (PDS).
Any time the battery terminal has been disconnected, the driver's and front passenger's door power window MUST be re-initialized.
Warranty Information
Initialization Procedure
Driver and Passenger Door Power Window Switch
1. Turn the ignition switch to the "IG-ON" position.
NOTE
When not initialized, the power window switch will blink.
2. Push down and hold the door power window switch to completely open the window.
3. Pull and hold up the door power window switch until the window closes. Continue holding the switch until the switch stops blinking and remains illuminated.
4. Check for proper operation of the "one-touch open and close" function by fully pushing the switch briefly to the "DOWN" and "UP" positions.
NOTE
Jam protection function for the window becomes effective through the above initialization procedure.