Installation

AIR CONDITIONING: COMPRESSOR: INSTALLATION

1. INSTALL COMPRESSOR AND MAGNETIC CLUTCH

(a) Install the compressor and magnetic clutch with the 4 bolts.





Torque : 25 Nm (250 kgf-cm, 18 ft-lbf)

NOTICE:
Tighten the bolts in the order shown in the illustration to install the compressor and magnetic clutch.

(b) Connect the connector.

2. INSTALL SUCTION HOSE SUB-ASSEMBLY

(a) Remove the attached vinyl tape from the hose.

(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor and magnetic clutch.

Compressor oil:

ND-OIL 8 or equivalent

(c) Install the O-ring to the suction hose sub-assembly.

(d) Install the suction hose sub-assembly to the compressor and magnetic clutch with the nut.





Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

3. INSTALL COOLER REFRIGERANT DISCHARGE HOSE NO.1

(a) Remove the attached vinyl tape from the hose.

(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor and magnetic clutch.

Compressor oil:

ND-OIL 8 or equivalent

(c) Install the O-ring to the cooler refrigerant discharge hose No.1.

(d) Install the cooler refrigerant discharge hose No.1 to the compressor and magnetic clutch with the nut.





Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

4. INSTALL GENERATOR ASSEMBLY Installation

5. INSTALL V-RIBBED BELT Installation

6. INSTALL V-BANK COVER SUB-ASSEMBLY

7. INSTALL FRONT FENDER APRON SEAL RH

8. INSTALL FRONT WHEEL RH

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

9. CHARGE REFRIGERANT Service and Repair

10. WARM UP ENGINE Service and Repair

11. INSPECT FOR REFRIGERANT LEAK Service and Repair